DIY Chevron Ring by apairandasquarediy.com

What you need:

• gold wire (I recommend 0.6mm)
• Wire cutters
• Round nose plyers

How to make it:

1. Cut a small length of wire
2. Fold it in half, use the plyers to make a point, and slowly pull it apart until you have the chevron pattern you want
3. Fold the wire around your finger
4. place the front of the ring on the back of the table, and fold the wires around your finger
5. Cut the wire shorter, but leave a bit of excess for twisting
6. Begin twisting, and eventually finish it off with the plyers